NG-2 GOBLIN flywheel nerf blaster deals secondary semi auto for talon mags

The NG-2 GOBLIN flywheel blaster is a 100% custom designed, high performance, semi auto flywheel blaster, designed to launch half length foam darts using standard talon mags. It is meant as back up blaster (side arm). Hence, the GOBLIN is a very compact blaster.
Kinetic energy <0.5 Joule.


Note: basically any color combination is possible. Use this link https://tinyurl.com/ng2-goblin

to find your combo and send us a screeshot after the purchase. We will then make sure you get the colors that you chose.

Battery recommendations:
-2s lipo: measurements approx. 58x30x15 mm. Both the 'Graphene 2s 950mAh 65c' from Outofdarts and the 'Turnigy Graphene Panther 1000mAh 2s 75c' from Hobbyking fit.

-3s lipo: measurements approx. 70x37x17 mm

The main motor cage is ABS and not PLA. So you do not have to worry about heat that is generated by the motors.

There are three versions:


VERSION (1): Fully assembled 2s
--------------------------------------------------------------
The blaster comes fully assembled with thick silicon wires and an XT60 connector already soldered. You only need to add the lipo and the talon mag.

Main features:
- Operation: Semi-automatic
- Operating voltage: 2s 7.2V (nominal)
- Material: ABS and PLA (and others)
- Motor have ball bearings.
What is in the package?
Fully assembled blaster with Xt60 connector. Plug and play. Talon mag and short darts are not included.

Power supply
Batteries are not part of this offer (difficulties with shipping etc). The blaster is equipped with a XT60 connectors.
--------------------------------------------------------------


VERSION (2): Fully assembled 3s
--------------------------------------------------------------
As version (A), but with 3s motors that feature ball bearings.
The blaster comes fully assembled with thick silicon wires and an XT60 connector already soldered. You only need to add the lipo and the talon mag.

Main features:
- Operation: Semi-automatic
- Operating voltage: 3s 10.8V (nominal)
- Material: ABS and PLA (and others)
What is in the package?
Fully assembled blaster with Xt60 connector. Plug and play. Talon mag and short darts are not included.

Power supply
The motors are rated for a 3s setup (max 12.6V). Batteries are not part of this offer (difficulties with shipping etc). The blaster is equipped with a XT60 connectors.
--------------------------------------------------------------


VERSION (3): printed parts only
--------------------------------------------------------------
This is the kit version; includes all 3D printed parts and screws. Without motors, wires and switch. Perfect if you want to install your own motors and electronic components.
--------------------------------------------------------------


DO NOT expose the blaster to heat (e.g. from sun). Temperatures above 45 °C will warp and permanently damage the product which is mainly made from PLA.

Legal disclaimer
Do not aim at eyes or face. Do not modify darts or dart blaster. This product is only intended to be used as outlined in the accompanying instruction manual. This item is not a toy, keep away
from children. In no event, regardless of cause, shall my3dbase GmbH be liable for any indirect, special, incidental, punitive or consequential damages of any kind as a result of this product, whether arising under breach of contract, tort (including negligence), strict liability or otherwise, and whether based on this agreement or otherwise, even if advised of the possibility of such damages.
The kinetic energy of the blaster does to exceed 0.5 joule (mass of the projectile 1 gramm) and no hot Gases are expelled from the device deals.

Magazine, darts and battery are not part of this offer.

my3dbase